NAP Spitfire Gobbler Getter Broadheads

The NAP Spitfire Gobbler Getter broadhead uses the Spitfire technology, one of the most trusted names when it comes to broadhead mechanical blades, for these turkey hunting heads. As well as using the sharpest possible Diamize blades the point is engineered to create the greatest possible shock as it enters the bird. It is designed to take turkeys down quickly.

The blades of this broadhead are incredibly sharp to create as large a haemorrhage as possible which means the knockdown speed is as fast as possible.

The Gobbler Getter broadheads are available in either 100 grain or 125 grain weights and the cutting diameter is 1-1/2”. In both cases these broadheads can be bought in packs of 3 and it is also possible to buy practice blades that fly exactly the same as the hunting blades.

Take a look at the selection of NAP Spitfire Gobbler Getter Broadheads listed for sale below. These broadheads are available at 100 grains and 125 grains and come in packs of three.

Buy NAP Spitfire Gobbler Getter Broadheads



NAP 60 250 Spitfire Gobbler Getter Broadheads 3 Pack
NAP 60 250 Spitfire Gobbler Getter Broadheads 3 Pack
$30.65
Time Remaining: 1d 14h 25m
Buy It Now for only: $30.65

NAP SpitFire Gobbler Getter 3 Blade 100 Grain Broadhead 3pk 60 250
NAP SpitFire Gobbler Getter 3 Blade 100 Grain Broadhead 3pk 60 250
$39.99
Time Remaining: 7d 2h
Buy It Now for only: $39.99

NAP Spitfire Gobbler Getter 100 gr 3 Blade Broadhead 3 Pack 60 250
NAP Spitfire Gobbler Getter 100 gr 3 Blade Broadhead 3 Pack 60 250
$37.00
Time Remaining: 16d 1h 5m
Buy It Now for only: $37.00

NAP Spitfire Gobbler Getter Broadheads 3 Pack 60 250
NAP Spitfire Gobbler Getter Broadheads 3 Pack 60 250
$35.13
Time Remaining: 28d 21h 48m
Buy It Now for only: $35.13



 

NAP Spitfire Gobbler Getter Broadhead Features

Spitfire Gobbler Getter Assembly/Installation Instructions

ASSEMBLY
1. Sandwich blade retention clip and blade together (Fig. 1).
2. Insert into ferrule slot. NOTE: Sharp edge of blade must face slot in ferrule.
3. Align holes in ferrule, blade and retention clip.
4. Insert pivot screw in threaded hole and tighten with screwdriver.
5. Repeat above steps for remaining blades.

DISASSEMBLY
1. With blades closed remove pivot screws with the screwdriver provided.
2. Carefully remove blades and retention clips.

 

New Archery Products cautions that the following procedures should be followed for greater safety and proper product performance.

It must be shot with the blades in the closed position.

The retention clips must be properly installed before it is shot.

If the blades are damaged it must not be shot.

Check the broadhead for debris or damage after each shot.

The blades should be replaced after every hunting shot.

It is important that the Shockwave broadhead is installed properly onto the shaft of your arrow. New

Archery Products has provided the following assembly instructions.

Visit the NAP Broadheads page to browse through the complete selection of broadhead arrow points that are made by the company.


cialis sans ordonnance